COURSE RECORDER KW950-CR

COURSE RECORDER KW950-CR
Loading...

COURSE RECORDER KW950-CR

$1,650.00

Description

The KW950-E is programmed to output a single line of data at certain intervals.

  • Printout on low cost printer
  • Digital heading repeater
  • Low cost replacement for “course recorders.”
  • Connects to a gyro and a GPS.
  • Highly reliable, 1000s in service.
The KW950-E is programmed to output a single line of data at certain intervals. The data is printed on a tandard low cost printer, or to a PC for recording on disk. The interval between outputs varies according to these rules, in order to minimise paper used, and to provide a good record of data.

a) One line output every 6 minutes on a 6 minute interval. (0, 6, 12 etc. 1/10th hour.) Paper usage on passage would be typically 4 pages per day.
b) An output if course changes by 2 degrees from the last output. This occurs no faster than at a 10-second interval. Paper usage during manoeuvring would be typically 3 pages per hour.
c) An output on demand by pressing the keypad AL button.

Specifications

Input 1

  • DC and rectified unsmoothed DC stepper, 4 to 90v.
  • 360:1 synchro up to 115v/90v. 50/60 400/500 Hz. 90X 400 Hz contactless transmitter.
  • Tracking rate = Frequency/3 deg/sec. (DC step 333 deg/sec)
  • Or: NMEA 0183 input, so both input channels are NMEA. Input 1 $HE, AG or GP, HDT,x.x,T

Input 2

  • NMEA 0183, GPS data or GPS and heading data.
  • These sentences provide the data required. $GPRMC or $GPGGA + $GPVTG + $GPZDA.

The system will not function as a course and data recorder without GPS input.

Output

  • 4800 baud. 8 bits. No parity. 1 stop bit. 5v CMOS RS422 and RS232 compatible.

Example: time, position, course, speed and course over ground, date.
12:30:00 51 30.521N 003 23.456 W 359 deg 12.0 sog 012 cog 25:12:99

Rudder Angle

  • If rudder angle (RSA sentence) is input along with GPS data the rudder angle is printed.

General Data

Display

  • 4 digit red LED 0.6 inch, 15mm high for heading speed etc. Adjustable illumination.

Control

  • 3 push button switches for align, increase, decrease.

Output

  • 5v CMOS drivers via 47 ohms

Power

  • 10 to 32 volts DC at 5 watts.

Connections

  • Via cable glands to lift-off terminal blocks. (Cables not supplied.)

Enclosure

  • DIN case 144 wide, 72 high, 142 mm deep. Flame retardant to DIN 43700
  • Supplied with a trunnion. Screw clamps for panel mounting optional extra

Approvals

  • IEC 60945 from AMI

Printer

  • 80 columns, 4800 baud, for fanfold or paper roll.
    Set printer for International English font, and Auto-LF.

Optional Add-Ons

  • EPSON LX-310