KW935 Propulsion and Telegraph interface

KW935 Propulsion and Telegraph interface

KW935 Propulsion and Telegraph interface

Product Description

The KW935 connects to a ship’s RPM indicator, thruster, rudder angle and telegraph. The voltages are turned into NMEA 0183 digital data.

The KW935 has four DC voltage input channels, all electrically isolated from ground and from each other. Inputs may vary from +/- 0.5v to 30 volts DC maximum and be either a single + or – polarity or both.

The input voltage is converted to an 8-bit byte by the analogue to digital converter. The translation of a variable voltage to a data output is made by the microprocessor, with look-up tables in the EPROM (example: +/- 5v = +/- 45 degrees rudder angle). Generally, for a VDR, the “raw data” values of 0 to +/- 100 can be recorded and translated to actual values on replay. The KW935 has a data combining (pass-through) facility to allow several devices to be connected.

Input4 channels +/- 0.5v to +/- 30 volts for full scale (extendable with additional resistor).
Adjustable. 50 K ohm input impedance. Low pass filtered.
Isolated at more than 500 volts level. Sampled at 1.6 second interval.
Analogue to digital conversion of 8 bits. 256 values. 1 % accuracy typical.
4-20 mA signals can be measured by the voltage across the line, terminated in 100 to 500 ohms.
The KW935 is not intended to have low resistance and be inserted into a loop with other receivers.
Input1 NMEA 0183 port.
Acts as data pass-through input channel so that data can be combined.
OutputNMEA 0183 port. 5 volt level CMOS via 47 ohms.
AlignmentThe input potentiometer is adjusted for full scale reading with a full scale input voltage.
FeaturesFeatures:- LEDs to indicate function. Hexadecimal switch to select data output formats.
Power18 to 30 volts DC at 2 watts. Isolated from ground
EnclosureDiecast aluminium enclosure 222 x 155 x 55 mm